The new Kep Titanium is the result of experience gained during years of development in the heart of our manufacturing facility and to continual improvements made thanks to daily input from the greatest of champions.
Lightweight, aerodynamic, powerful, the new KEO BLADE CARBON has all the assets to allow you to improve and optimize your performance until victory is yours. It is for these reasons that KEO BLADE CARBON is the unanimous choice of many champions who have made it a weapon of choice in the conquest of their greatest achievements.
Its new design completely integrates the blade for unrivalled aerodynamics. Equipped with a carbon body and blade, the Blade Carbon is available in a Ti version (titanium spindle) that weighs a mere 95g per pedal, or in a CrMo version (chromoly spindle) for a weight of 110g per pedal. It is available in three tension release levels: 12,16 and 20.
The spindle of the new CARBON BLADE has been completely redesigned. It is built around an oversized axle and spindle that pass through internal roller and needle bearings located directly under the pedal platform. This new construction allows a gain of approximately 2 to watts at 100 rpm.
The distance between the roller and needle bearings has been increased by 25%. This provides more rigidity along the entire length of the spindle, and as a consequence, improved power transmission.
Special attention has also been given to ensure that it is water resistant. Weather resistance has been improved by 120% for even more reliability and longevity. To accomplish this, the new spindle received an updated end plug with an O-ring washer and has also been equipped with an internal, double-lipped seal.
LOOK axles are only approved after a rotational test of 2 million cycles at 100 rpm with a load of 90 kg on the centre of the pedal and an eccentric rotation (which creates stress on each revolution). This is equivalent to a sprint by André GREIPEL of 1700 watts at 100 rpm for 333 hours! This test is much more demanding than the current standard, the ISO 4210.
To meet the demands of the most demanding cyclists, especially competitors, the pedal-cleat system must allow efficient power transfer thanks to a broad and rigid platform.
The platform of the CARBON BLADE is fitted with a 67mm-wide stainless-steel plate, optimizing the cleat/pedal contact areas, regardless of pedalling angle.
With 700 mm² of surface area, the CARBON BLADE offers an optimized contact platform for an efficiency and power transfer that is unmatched on today’s market.
Its weight / power ratio positions it well above the competition
Using a carbon body lightens the weight of the pedal and provides an additional gain in stiffness for improved power transfer.
BLADE technology is a major technical innovation in the history of the automatic pedal because of its many benefits: LIGHTWEIGHT, AERODYNAMIC, ULTRA-SECURE WHEN CLIPPING IN AND OUT
Suggested use - Race.
Pedal Body - Carbon.
Axle - Titanium.
Bearings - 1 roller bearing and 1 needle bearing.
Stack height - 14.8 mm.
Distance Pedal Spindle / Crank - 53 mm.
Platform width - 67 mm.
PLATFORM SURFACE AREA: 700 mm².
Release Tension - Pedals are installed with “16” carbon blades + additional “12” carbon blades (“20” carbon blades sold separately)
Cleats - Kéo Cleats-Grey
Float - 0 °, 4.5 ° or 9 ° according to the cleat colour (Black, Grey, Red
Weight - 190g pair (248g per pair with cleats and screws)